The chassis is made in Salt Lake City, UT. The steel sheets are cut, bent, formed, and finished all by US labor. After that process the steel is powder coated to a high gloss red done by US labor. We silk-screen the chassis and assemble the PCB′s at our Salt Lake City factory. We flow solder the PCB′s, send them to post flow assembly where we add the fragile components soldering them in by hand. We test the PCB′s and send them to mechanical assembly were the PA253 is completed then tested again. The boxes that we use are made in a facility just a few miles from us. Even the out bound shipping boxes, biodegradable peanuts and printing materials are made in the US. Yes, some of the parts used like the power adapter, jacks, knob, and IC′s are not made by us and come from countries other than the US. We pride ourselves on keeping as much as we can in the US including 100% of the product development and design.
SPECIFICATIONS:
Nominal Output Power 50 watts RMS @ 4 ohms — 42 watts RMS @ 8 ohms
Power Stage Gain: 32.6 dB @ 8 ohms — 31.4 dB @ 4 ohms
Input Impedance: 10k – 5Hz to 100kHz
Connection Output Impedance: 4 to 8 ohms speakers
Output Impedance: < 0.32 ohms from 20 Hz to 20 kHz (Measured under 8 ohms)
Dampening factor: > 100
Frequency Response: 3Hz to 43kHz
Phase shift: 0 Deg.
Volume Max gain: 33.7 dB no load
THD: .015% @ 1KHz
Rise Time: < 0.9 µs
Slew Rate: > 20 V/µs, peak-peak
DC Output Voltage: ± 0 mV
Crosstalk: < – 95 dB from 20Hz to 20kHz
S/N Ratio: >100 dB unweighted
PWR: 24 VDC @ 4A (KS100DU) Included.
Power efficiency: 90%
Size: 5.5″w x 3.5″d x 1.25″h
